Maintenance (Entry level)

  • Department: Production
  • Reports To: Maintenance Manager
  • Date: August 23, 2021
  • Location: Baldwyn, MS
  • Pay Scale: $17 - $18/hr (Depending on Experience)

Mission

CEW is a Custom Injection Molding and Polyurethane Foam products supplier specializing in Consumer Products for North America. We create a value for our shareholders, customers, and team members by focusing on superior quality, outstanding customer service, innovation and Manufacturing Excellence.

Let’s build something amazing…

Essential Job Duties

  • Basic Hydraulic / Pneumatic / Electrical / Plumbing Knowledge
  • Basic knowledge in use hand tools
  • Read and Understand Hydraulic / Pneumatic diagrams for use in maintenance activities
  • Read and Understand electrical schematic ( Low – High voltage ) for use in maintenance activities
  • Ability to use basic electrical tools – amp meter, volt meter
  • Ability to use measurements instruments – Caliper & Micrometer
  • Proven ability to maintain organized, neat work areas and accurate inventory of equipment and supplies
  • Forklift Certified
  • Ability to perform basic Preventive Maintenance of ALL Equipment
  • Understanding of injection presses with ability to troubleshoot problems
  • Knowledge in change EOAT and start up FANUC robots – Need to be certified by Maintenance manager
  • Basic Welding and Fabrication skills validated and demonstrated on specific project
  • Ability to troubleshoot and repair ALL secondary equipment (AMM, BBM, etc.) for mechanical and electrical issues.
  • Demonstrated ability to read Injection Molding Machine prints and schematics
  • Demonstrated advanced understanding of Material Handling System and all components and ability to train others
  • Ability to construct and repair all EOAT
  • Active ownership of at least (1) Workstation Expectation area
  • Basic understanding of Robots with ability to trouble shoot programing and equipment itself
  • Ability to properly communicate and conduct Safety Training activities for team. (LOTO, Fall Protection, PPE)
  • Demonstrated working knowledge of PLC programming (AB and Festo)
  • Demonstrated advanced understanding of Electrical, Water & Chiller System and all components, along with ability to train others on basic functionality and troubleshooting of these systems
  • Detailed understanding of Robots with ability to perform programming changes along with training others to do the same
  • Proven ability to run all injection molding equipment with a solid foundation of processing capability
  • Demonstrated knowledge in the implementation of HMI
  • Demonstrated ability to create, record proper LOTO procedures on equipment
  • Demonstrated application of Advanced Injection Molding Processing Skills
  • Ability to perform all Advanced Preventive Maintenance of all Equipment and proven ability to train others on basic PM requirements
  • Advanced Welding and Fabrication skills demonstrated through specific project completion
  • Documented participation in at least (1) Continuous Improvement Event annually
  • Demonstrated advanced PLC programing capabilities
  • Demonstrated advanced knowledge of PLC programming (AB and Festo)
  • Demonstrate ability to remove, put and take dimensions of the 2 major components of the injection presses:
    1.- Screw
    2.- Barrel
    3.- Check ring

Disclaimer

The above statements are intended to describe the general nature and level of work being performed by employees assigned to this classification. They are not intended to be construed as an exhaustive list of all responsibilities, duties or skills required of all personnel so classified.

Ready to work for CEW?

Apply Now
Ready to work for CEW? Apply Now
Terms and Conditions of Purchase
Terms and Conditions of Sale
  Privacy Policy
CA Privacy Notice
  Copyright © 2022 CEW. All Rights Reserved.   facebook   twitter   linkdin